Canon Camera Basic Guide Flash metering
Metering for ambient lighting conditions and flash metering has totally different requirement. The metering for ambient lighting condition is done before the shutter of the camera is opened. In the Canon EOS camera, ambient light metering is done when you press the shutter button halfway down. Flash Pulse metering however is done when the shutter button is press fully down. There are two ways to meter for flash pulse automatically. One way is by measuring the flash pulse as it is being released. The other way is to do a pre-flash test. This is achieved by a low powered test pulse of a calculated brightness before the shutter opens.
Canon uses both these two methods for the metering of the flash pulse. The first way is called the “Through The Lens” (TTL) system. It was first used by Canon in their T90 model during it debut in the 1980s. Later the TTL system became a standard facet of the EOS range of Cameras. In fact the T90 became the only Non EOS camera to ever use the TTL flash metering system.
The TTL system works by calculating the amount of light which is reflected off the subject into the camera after the flash light is emitted by the flash unit. It actually measures the light which is reflected of the film in real time and this done by using an OTF (Off The Film) sensor. When enough light has entered the OTF sensor, the flash will be deactivated. Due to the fact that the Canon EOS Digital cameras do not use films, the Digital range of Canon cameras does not support the TTL system.
The sequence of operation of the TTL system is as follows;
1. Once the shutter button is depress midway, the metering for ambient lighting takes places. The speed of the shutter and size of the aperture is programmed by the camera or User depending on which program mode the camera is using. For example whether the camera is using the AV, P or M mode.
2. Only when the shutter button is depressed all the way, the internal mirror is turn up and exposes the film. Power is then sent to the flash unit which will emit a flash light to illuminate the scene. The length of the flash pulse is determined by the OTF sensor in the camera which is metered for normal operational conditions. If the picture is taken under bright lighting conditions, the auto fill reduction will take effect and reduce the illumination of the Flash.
3. When the foreground is sufficiently illuminated, the power supply to the flash unit is terminated which in turn extinguishes the flash light. The shutter is opened during the entire duration of its speed run. After that, the shutter then closes and the mirror flips back to it original position. For those cameras which have a warning light to confirm the success of the flash exposure operation, the warning light will then glow to indicate the success of the flash metering operation.
You have to note that the OTF sensor, reflect the amount of light off the film. Therefore it follows that the composition of the film will also affect the amount of light which will be reflected. Normally this will not be an issue as all cameras are adjusted to work with normal films. This is only an issue if you use specially coated films which have a different level of tolerances to light exposure.
If you enjoyed this post, make sure you subscribe to my RSS feed!
Tags: arts, cameras, canon, canon camera, computer;internet, digital camera, Entertainment, Photography, shopping
